Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car



Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
- Coupling
   + Coupling
   Driveshaft
   + Power shafts
   - Differential
      Dismantling, assembly and check of differential
      Dismantling and assembly of a reducer of the main transfer and adjustment of gaps of gear wheels
      Determination of thickness of adjusting laying and its installation in the reducer case
      Check and adjustment of a gap of a flange
      Dismantling and assembly of a reducer of the main transfer and adjustment of gaps of gear wheels (model 140.28/032/O33 till 31.05.94 of the issue, 140.042/043/063/1 and with a diameter of 210 differential of mm)
      Dismantling and assembly of differential with automatic blocking
      Replacement of the cylinder of differential with automatic blocking (model 140.028/032/033 till 31.05.94 of the issue and 140.1 with a code 211a)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


79c5991e

Replacement of the cylinder of differential with automatic blocking (model 140.028/032/033 till 31.05.94 of the issue and 140.1 with a code 211a)

Diameter of differential is 210 mm.


Replacement of the cylinder of differential with automatic blocking (diameter of differential of 210 mm)

30 — the Lock ring
33b — the Flange
33c — the Ball bearing
50 — the Reducer
54 — the Back cover

56, 56b — Bolts
70b — the Piston
70d — the Rubber cover
70h, 70j — Sealing rings


 PERFORMANCE ORDER

1. Remove a reducer (50).
2. Merge oil from a reducer.
3. Remove a back cover (54).
4. Disconnect a lock ring (30).
5. Remove a flange (33b).
6. Remove the ball bearing (33c).
7. By means of the screw-driver to a vypressuyta a rubber cover (70d) from a bearing cover.
8. Insert a stripper (07l) into the piston (70b) and remove a sealing ring (70j), remove a rubber cover (70d) from the piston (70b), remove the piston (70b) from a side cover of the bearing, weaken a tube of a sapun (shooter).
9. Remove sealing rings (70h) and (70i) and do not establish them twice. Grease carefully the piston (70b) with hydraulic liquid (specification 343.0) and press it. Grease connection of a sapun after a piston press fitting. At a piston press fitting in a side cover of the bearing, be convinced that grooves were combined with a roller finger (70c) or an opening (shooter).
10. Replace a sealing ring (70j), - for this purpose, grease a sealing edge with universal gipoidny transmission liquid and press it by means of a drift (073).
11. Using a press of small diameter (072b), press a rubber cover (70d) on the piston.
12. By means of a press of bigger diameter (072a), press a rubber cover (70d) on a side cover of the bearing.
13. Further all procedures are carried out upside-down.
14. Pump over hydraulic system of blocking of differential.