Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car


Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Angles of installation of wheels of the car, clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 of the issue)
      Removal and installation of the blocking cylinder (model since 1.09.95 of the issue)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of the steering drive
      Removal and installation of cross steering draft
+ Body
+ Onboard electric equipment

79c5991e

Removal and installation of the blocking cylinder (model since 1.09.95 of the issue)

Removal and installation of the blocking cylinder (model 140 since 1.09.95 of the issue)

Removal

 PERFORMANCE ORDER

1. Remove the lock of blocking of a steering shaft, remove the protective plug (36d) from the blocking lock.
2. Press a rack (shooter) and take the lock of ignition (S2/1) with the lock of blocking of a steering shaft from the protective plug (36d). The blocking cylinder (36) can be replaced together with the protective plug (36d) and a cover (36b). On models with AT the valve of blocking of the parking (37h) settles down on the lock of ignition (S2/1) too.

Installation

 PERFORMANCE ORDER

1. Turn the blocking cylinder (36) in situation "1" by means of a key (36c) and press the new plug (36d) until the blocking doggie (36h) is not blocked in the necessary situation.
2. Take a key.
3. Install a cover (36b) on the protective plug so that the lock ring (36g) was blocked in the necessary situation.
4. Press the lock of ignition (S2/1) with a blocking shaft in the protective plug (36d) so that it was blocked in the necessary situation.