Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car

Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Angles of installation of wheels of the car, clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 of the issue)
      Removal and installation of the blocking cylinder (model since 1.09.95 of the issue)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of the steering drive
      Removal and installation of cross steering draft
+ Body
+ Onboard electric equipment

Removal and installation of the lower steering shaft

Removal

PERFORMANCE ORDER

1. On steering of the 1st version unhook an ear (shooter) from a blocking plate (96a), turn off a nut (96)
2. On steering of the 2nd version turn off a nut (96).

Installation

PERFORMANCE ORDER

1. On steering of the 1st version fix new laying (96a) on the lower shaft and record it.
2. On steering of the 1st and 2nd versions at first wrap a nut (96) on the top steering shaft (70g). Establish the lower steering shaft on a nut (96) and wrap them together, continuing to rotate both parts until they are not blocked in shlitsevy connection.
3. Turn the lower steering shaft (80a) so that the fork of the hinge was established down. Insert the adjusting tool (075) into a groove of the top shaft and establish a fork of the lower shaft (80a) so that it was established in parallel to "X" to the adjusting tool (075). 4. Establish a steering wheel on a steering shaft. Tighten a nut (96).
5. On steering of the 1st version: block a nut (96) for what press laying (96a) in a groove over a nut.