Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car


Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Angles of installation of wheels of the car, clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 of the issue)
      Removal and installation of the blocking cylinder (model since 1.09.95 of the issue)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of the steering drive
      Removal and installation of cross steering draft
+ Body
+ Onboard electric equipment

79c5991e

Removal and installation of the pendular lever of the steering drive

Removal

Details of installation of the pendular lever


 PERFORMANCE ORDER

1. Separate from the pendular lever (26) cross steering draft (10).
2. Separate from the pendular lever (26) average draft (11).
3. Remove the thermofilter (26h).
4. Give a nut (26b), take the screw (26a) and remove the pendular lever (26) assembled with a bearing ring (26i).
5. Having hooked the screw-driver sealing sponges, take the plug from a bearing ring.
6. By means of a stripper (061) No. 129 589 00 33 00 take a rubber pillow (26f).

Installation

 PERFORMANCE ORDER

1. Installation is made upside-down. The rubber pillow has to be put against the stop by means of special adaptation (062) No. 201 589 08 43 00.
2. Correctly adjust the landing size and assemblies of the pendular lever with a bearing ring (and = 22.7 mm).
3. Replace all самоконтрящийся fixture.
4. Самоконтрящуюся a nut of fastening of the pendular lever to the bearing tighten 120 Nanometers with effort.


At the correct position of the spherical hinge adjusting situation can vary within at most 5 mm.