Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car



Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
- Engine
   Check of a compression in engine cylinders
   Check of the engine by means of the vacuum gage
   Belt of the streaming drive of auxiliary units
   + 6-cylinder petrol engines (M104.944 and M104.990/994)
   + 8-cylinder petrol engines (M119.970/981 and M119.971/981)
   - 12-cylinder petrol engines (M120.980/982)
      The air cleaner - installation details
      Covers of heads of the block of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      The valve of recirculation of the fulfilled gases - installation details
      Air supply pump
      Removal and installation of the top forward covers
      Heads of the block of cylinders
      Removal and installation of a cover of a chain of the GRM drive
      Replacement of a chain of the GRM drive
      The GRM drive - the general information, service of components
      Natyazhitel of a GRM drive chain
      Camshaft regulator
      Removal and installation of camshafts
      Check of phases of gas distribution
      Check and adjustment of position of camshafts
      Replacement of the directing plugs of valves
      Measurement of diameters of cylinders
      Removal and installation of pistons
      Check of rods
      Removal and installation of a bent shaft
      Removal and installation of the pallet of a case of the engine
      The oil level sensor switch - installation details
      The oil pump - a design and details of installation
   + 6-cylinder diesel engines (OM603.971)
   + 6-cylinder diesel engines (OM606.961)
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


79c5991e

Camshaft regulator

Removal

Details of installation of the regulator of the camshaft

1 — the Directing lever of the right head of the block of cylinders
2 — the Directing lever left
heads of the block of cylinders
3, 15 — Bolts
4 — Fittings

5 — the Lock finger
6 — the Nut
12 — the Cover
13 — a camshaft Asterisk
14 — the Plunger
16 — the Flange


 PERFORMANCE ORDER

1. Remove the top covers (30) and (30a).
2. Remove the directing levers (1) and (2).
3. Turn off a bolt (3) and remove fittings (4).
4. Turn off a nut (6), - hold the camshaft (22) from a provorachivaniye a key (25).
5. Uncover (12), an asterisk of the camshaft (13) and an adjusting plunger (14). Turn off a flange (16) from the inlet camshaft (22) and remove it.

Installation

 PERFORMANCE ORDER

1. Install a flange (16) on the camshaft (22). Pay attention to an adjusting finger (21).
2. Tighten a flange (16) to the camshaft (22). Hold the camshaft (22) with a key (25) and tighten bolts (15).
3. Establish an adjusting plunger (14) on a flange (16) in the fixed situation, rotating it clockwise.
4. Establish an asterisk of the camshaft (13) on an adjusting plunger (14) in the fixed situation, rotating it counterclockwise.
5. Establish a cover (12).
6. Install fittings (4). The finger (shooter) in fittings (4) has to be combined with an adjusting plunger (18).
7. Screw a bolt (3), holding fittings (4) for a lyska (shooter).