Mercedes S-Class W-140

1991-1999 of release

Replacement of an epiploon of a back cover of the transmission

Details of installation of an epiploon of a back cover of the transmission


2 — the Driveshaft 5, 21, 200a — Bolts 6, 20, 36 — Washers 7, 35, 88, 200 — Nuts	18 — an engine Support 19 — an engine Arm 56 — the Epiploon 87 — the Flange

Removal

Details of installation of an arm of a support of a suspension bracket of the power unit


18 — the Support of a suspension bracket of the power unit 19 — the Arm 21 — Fixing bolts 35 — the Fixing nut

PERFORMANCE ORDER

1. Lift the transmission by means of a jack. 2. Turn off a nut of fastening of a support of the engine (35). Turn off bolts (21) with washers and remove an arm (19) together with a support of an engine mount (18).
3. Unscrew the driveshaft from the transmission. Turn off a bolt (8) of fastening of a shaft of a speedometer (9) and remove it.
4. Weaken adjusting plugs in a driveshaft flange. For this purpose use a drift with a diameter of 10 mm and about 150 mm long.
5. Weaken a nut of the driveshaft and move the driveshaft from a flange towards a back part of the car.
6. Turn off bolts of basic assembly (200a).
7. Turn off a nut of fastening of a flange of the transmission.
8. Remove a transmission flange.
9. Having hooked the screw-driver, take an epiploon from a transmission cover by means of the screw-driver.

Installation

Installation is carried out as it should be, the return to removal.